Execution of the colon hydrotherapy with Superstream

A step by step manual for the execution of the colon hydrotherapy with Superstream A / B.

Preparation

Open the angle valve that is connected to the water inlet hose and check the power supply.

Switch on the device, set the operating mode and temperature

Switch on the device with the "START / STOP" key.
Choose the operating mode by pressing the "MODE" key. You have 3 operating modi available: "FREE RUN", "TIME CTRL" and "VOL CTRL". With "FREE RUN" the colon hydrotherapy is not being stopped until you press the "START / STOP" key. "TIME CTRL" presets the therapy time and "VOL CTRL" presets the water volume. You set the desired value for the therapy time or the water volume with the "<>" keys.

Adjust the water flow rate

Adjust the water flow rate with the valve that is connected to the water inlet hose. Hold the nozzle into the sink or the toilet and adjust the water flow rate to about 0,8 l/h.

Sit upright on the toilet

Sit on the toilet in a normal, upright position and relax.

Locate your anus

Move the nozzle from behind your back under your bottom and locate your anus.

Preheat the water

Press the "START / STOP" key to preheat the water to the desired temperature. The water flow starts and the operation mode now indicates "PREHEAT". As soon as the water reaches the preset temperature, the device indicates "READY". If you have preset the therapy time or water volume, the respective counter starts running.

Start the water injection

Press the nozzle gently on your anus and let the water flow into your colon. Relax and keep your body in an upright position.
Click here for a table with indicative information about the water volume in relation to the body height and the desired cleansing depth of the colon during a colon hydrotherapy.

Finish the water injection

When the preset therapy time or water volume (see point 2) is reached, the device stops the water flow automatically. When the water flow stopped, put the nozzle on the hanger.
You can also interrrupt the therapy at any time by pressing the "START / STOP" key.

Massage and excretion

If possible, keep the water for 1 - 3 minutes in your body to dissolve encrusted faeces. During that time, gently massage the abdominal wall starting from the lower left part, going up under the breastbone then moving down to the lower right part.
The water is then released from the colon directly into the toilet. It may take a couple of minutes until all the water is being released from the colon.

Repeat the cycle 3 - 4 times

Repeat the cycle from introducing the water (point 7) til excreting the water (point 9) 3 - 4 times to achieve a deep colon cleansing.
At the end of the last cycle, you can add ozone to the water (only available with Superstream A).